The URE Seal H2O is a two part product. You can follow the instructions on the bucket to mix them, however you can simply mix half of the white liquid with half of the transparent liquid and fill up with water while stirring thoroughly to make an homo-gene mixture.
Use a back pack sprayer to spread the sealer evenly and on the edges, close to walls and screen enclosures, you can use a roller to not spill on it. On the coping we suggest using a paint brush to avoid dropping too much product into the pool. This product is water base and dissolves in the water, therefore do not worry if you spill some inside the pool, as this is normal.
After applying the first coat, wait between one half to one hour, depending on the weather, to apply the second coat. After finishing this process, wait 1 day to put any furniture back on the patio and up two days to drive over the pavers on a driveway to avoid tire marks.
In addition, pavers do not need to be completely dry to apply the sealer, just make sure you have no water puddles on them, otherwise the URE SEAL H2O will not stick on the pavers. When its dry, the sealer turns into a film, therefore after mixing if you do not use it you will have to throw away the product. In addition, do not mix all the product at once, do it by steps as needed. To clean the pump you can just wash it with water 2 or three times, than fill it up and spray until you don’t see more the white liquid spraying out.
In conclusion, if you find that you don’t want to do-it-yourself sealing, call Brick Paver Sealing and we can do the job right while you relax.